For grinding of automobile crank shafts. Gives an excellent finish and vibration free operation.

For grinding of automobile crank shafts. Gives an excellent finish and vibration free operation.

FA precision hydraulic surface grinding machine with milling facility; ideal for Engine Rebuilders, Manufacturers and General Engineering Applications. In automotive sector, it is capable of grinding and milling of cylinder blocks and heads made of cast iron or aluminum alloy.
Two models - SG1500/35 and SG 1500/40

For reboring of automobile, marine and stationary engines of different sizes with milling facility.

For reboring of automobile, marine and stationary engines of different sizes.

Models - CB 1500, CBM 1500

For reboring of automobile, marine and stationary engines of different sizes.

Models - CBM 1300, and CB 1300.

For reboring of automobile, marine and stationary engines of different sizes.

Models - CB 750, CB 850

Fly Wheel Grinder

Boring capacity 86-110
Maximum boring head travel 525mm
Spindle speed (variable) 250 - 1250

One models - VB-750

A precision machine for machining of new connecting rods and for re conditioning of worn connecting rods. Carriage is provided with manual and auto feed to give a fine finish while boring.

A heavy duty high precision main line boring machine for internal combustion engines, also suitable for other horizontal boring applications.

A high precision honing machine giving a cross hatch finish and close dimensional accuracy to engine cylinders.
Three models - CH 350, CH 500 and CH 600.

For re sharpening of cutting edges of tools used in machines like Line Boring, Cylinder Boring, Valve seat Cutting and others by grinding and lapping to correct angles with required clearances. Separate wheels for grinding and lapping

To remove minute quantities of material from the joining faces of the cap and rod. Can also be used for removing material from the contact faces of main bearing caps before line boring.

To remove minute quantities of material from the joining faces of the cap and rod. Can also be used for removing material from the contact faces of main bearing caps before line boring.

For straightening of Crank shafts at the seat of distortion / bent due to mechanical and thermal stresses.

For aligning the connecting rods of automobile engines such that the bores of the connecting rod are parallel at all the points.

By using Form tools on this machine, the complete valve seat geometry including seat angle and inner and outer angle is formed by a single operation. Suitable for cutting valve seats of width 1.5 - 6 mm and seat diameter 20 - 100 mm and any type of cylinder head using interchangeable spindles and tools.